Release : 1.1f 672 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
26.21 passive-interface default
This command suppresses routing updates on all interfaces and the no form of the command
enables routing updates on all interfaces.
passive-interface default
no passive-interface default
Mode
Router Configuration Mode
Example
SMIS(config-router)# passive-interface default
All the OSPF interfaces created after the execution of this command will be passive.
This is useful in Internet service provider (ISP) and large enterprise networks where many of the
distribution routers have more than 200 interfaces.
Related Commands
passive-interface vlan – Suppresses routing updates on an interface
show ip ospf interface – Displays OSPF interface information
show ip ospf request-list – Displays OSPF Link state request list information
To Next Page
Loading...
