Release : 1.1f 681 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
26.30 ip ospf authentication-key
This command specifies a password to be used by neighboring routers that are using the OSPF
simple password authentication. The no form of the command removes a previously assigned
OSPF password.
ip ospf authentication-key <password (8)>
no ip ospf authentication-key
Mode
Interface Configuration Mode
Example
SMIS(config-if)# ip ospf authentication-key asdf123
The password string can contain from 1 to 8 uppercase and lowercase alphanumeric characters.
A separate password can be assigned to each network on a per-interface basis.
All neighboring routers on the same network must have the same password to be able to
exchange OSPF information.
Related Commands
ip ospf authentication – Specifies the authentication type for an interface
summary-address – Creates aggregate addresses for OSPF
show ip ospf info – Displays general information about OSPF routing process
To Next Page
Loading...
