Release : 1.1f 604 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
23.30 show ipv6 pim thresholds
This command displays threshold configured for SPT, RP thresholds, and rate limit values for
both SM and DM.
show ipv6 pim thresholds
Mode
Privileged EXEC Mode
Example
SMIS# show ipv6 pim thresholds
PIM SPT Threshold Information
-----------------------------
Group Threshold : 111
Source Threshold : 222
Switching Period : 100
PIM SPT-RP Threshold Information
--------------------------------
Register Threshold : 333
RP Switching Period : 300
Register Stop rate limit : 400
Related Commands
set ip pim threshold – Configures the SPT group or source threshold
set ip pim spt-switchperiod– Configures the period (in seconds) over which the data
rate is to be monitored for switching to shortest path tree
set ip pim rp-threshold– Sets the threshold at which the RP initiates switching to source
specific shortest path tree
set ip pim rp-switchperiod– Sets the period (in seconds) over which RP monitors
register packets for switching to the source specific shortest path tree
set ip pim regstop-ratelimit-period– Sets the period over which RP monitors number
of register packets after sending the register stop message
set ip pim pmbr– Enables or disables the PMBR (PIM Multicast Border Router) Status
ipv6 pim dr-priority– Sets the designated router priority value configured for the router
interface
To Next Page
Loading...
