Release : 1.1f 872 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
31.40 show ipv6 ospf interface
This command displays the OSPFv3-related interface information.
show ipv6 ospf interface [ vlan <vlan-id(1-4069)> ]
Syntax Description
Vlan - VLAN Identifier
Mode
User/Privileged EXEC Mode
Example
SMIS# show ipv6 ospf interface vlan 1
OSPFv3 Interface Information
Interface Name: vlan2 Interface Id: 1 Area Id: 0.0.0.0
Local Address: fe80::211:22ff:fe33:4412 Router Id: 11.0.0.2
Network Type: BROADCAST Cost: 10 State: WAITING
Designated Router Id: 0.0.0.0 local address: (null)
Backup Designated Router Id: 0.0.0.0 local address: (null)
Transmit Delay: 1 sec Priority: 1 IfOptions: 0x0
Timer intervals configured:
Hello: 10, Dead: 40, Retransmit: 5, Poll: 120
Demand Circuit: Disable Neighbor Probing: Disable
Nbr Probe Retrans Limit: 10 Nbr Probe Interval: 120
Hello due in 4 sec
Neighbor Count is: 1
Adjacent with the neighbor 11.0.0.1
Related Commands
area - virtual-link – Sets the Virtual Link between Areas
ipv6 ospf area – Enables OSPFv3 for IPv6 on an interface
ipv6 ospf demand-circuit – Configures OSPFv3 to treat the interface as an OSPFV3
demand circuit
ipv6 ospf retransmit-interval – Sets the time between LSA retransmissions for
adjacencies belonging to an interface
ipv6 ospf transmit-delay – Sets the estimated time taken to transmit LS update packet
over a particular interface
To Next Page
Loading...
