Release : 1.1f 873 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
ipv6 ospf priority – Sets the router priority, which helps to determine the Designated
Router for this network
ipv6 ospf hello-interval – Specifies the time interval between the OSPFv3 hello packets
on a particular interface
ipv6 ospf dead-interval – Configures the router dead interval
ipv6 ospf poll-interval – Configures the larger time interval, in seconds, between the
Hello packets sent to an inactive non-broadcast multi-access neighbor
ipv6 ospf metric – Specifies the metric value for sending a packet on an interface
ipv6 ospf network – Sets the network type for an interface
ipv6 ospf neighbor – Configures a neighbor on non-broadcast networks and sets the
priority value for the neighbor if specified
ipv6 ospf passive-interface – Configures an OSPFv3 interface to be Passive
ipv6 ospf neighbor probing – Enables neighbor probing on demand-circuit enabled
interface ipv6 ospf neighbor-probe retransmit-limit – Sets the number of
consecutive LSA retransmissions before the neighbor is deemed inactive
ipv6 ospf neighbor-probe interval – Sets the number of seconds, that indicates how
often neighbor will be probed
To Next Page
Loading...
