Release : 1.1f 530 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
21.4 debug ip dvmrp
This command enables debugging support for DVMRP. The no form of the command disables
debugging support for DVMRP.
debug ip dvmrp {[neighbor][group][join-prune][i/o][mrt][mdh][mgmt] |
all }
no debug ip dvmrp { [neighbor][group][join-prune][i/o][mrt][mdh][mgmt]
| all}
Syntax Description
neighbor - Neighbor Discovery messages
group - Group Membership messages
join-prune - Join or Prune messages
i/o - Input/Output messages
mrt - Multicast Route table update messages
mdh - Multicast Data Handling messages
mgmt - Management Configuration messages
all - All traces
Mode
Privileged EXEC Mode
Defaults
Debugging is disabled by default.
Example
SMIS# debug ip dvmrp all
DVMRP must be enabled in the device prior to the execution of this command.
Related Commands
set ip dvmrp – Enables / disables DVMRP in the switch
set ip dvmrp - interface – Enables DVMRP in the interface
show ip dvmrp – Displays the DVMRP details
To Next Page
Loading...
