Release : 1.1f 840 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
31.12 area - range
This command creates the Internal Aggregation Address Range. The Internal Address Range is
of two types
Type-3 Aggregation
Type 7 Translation Aggregation
area <Area-ID> range <IPv6-Prefix> <Prefix-Length> [{ advertise |
notadvertise }] {summary | Type7} [tag <tag-value>]
Syntax Description
Area-ID - A 32-bit integer
range - Internal Aggregation Address Range
IPv6-Prefix - The IPv6 address prefix of the range
Prefix-Length - The prefix length of the address range
advertise - Flushes out all the routes (LSAs) falling in the range and generates aggregated
LSA for the range
not-advertise - Suppresses routes that match the prefix/prefix-length pair
summary - Summary LSA
Type7 - Type-7 LSA
tag - Sets the tag value for the aggregated route
Mode
Router Configuration Mode
Defaults
tag - 0
Example
SMIS(config-router)# area 1.1.1.1 range 3ffe:5000:481d::5 80
advertise Type7 tag 20
When parameter summary is specified, the configured range is used for
aggregating Type-3 LSA.
When parameter Type7 is specified, the configured range is used for aggregating
Type-7 LSAs.
The optional parameter tag is used to set the tag value for the aggregated route.
To Next Page
Loading...
