Release : 1.1f 833 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
31.6 timers spf
This command configures the delay time6 and the hold time between two consecutive SPF
calculations.
The no form of the command sets the default values for spf-delay and spf-holdtime.
timers spf <spf-delay> <spf-holdtime>
no timers spf
Syntax Description
spf-delay - The interval by which SPF calculation is delayed after a topology change
reception.
spf-holdtime - The delay between two consecutive SPF calculations.
Mode
Router Configuration Mode
Defaults
spf-delay - 5
spf-holdtime - 10
Example
SMIS(config-router)# timers spf 10 20
Related Command
show ipv6 ospf - General Information – Displays general information about the
OSPFv3 routing process
To Next Page
Loading...
