Supermicro SSE-G48-TG4 - Neighbor - Route-Reflector-Client

Release : 1.1f 733 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
27.25 neighbor - route-reflector-client
This command configures the Peer as Client of the Route Reflector and the no form of the
command resets the Peer as conventional BGP Peer.
neighbor <ip-address> route-reflector-client
no neighbor <ip-address> route-reflector-client
Syntax Description
ip-address - Peer's Remote IP address
route-reflectorclient - Specifies the BGP peer as a client of the Route-Reflector
Mode
Router Configuration Mode
Example
SMIS(config-router)# neighbor 23.45.0.1 route-reflector-client
BGP Speaker Local AS number must be configured.
Route Reflector must be enabled.
Peer must be created and peer AS must be configured.
Related Commands
router bgp – Sets the AS number of the BGP Speaker
show ip bgp rfl info – Displays info about RFL feature