Release : 1.1f 812 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
30 RIPv6
IPv6 RIP functions the same and offers the same benefits as RIP in IPv4. RIP enhancements for
IPv6, detailed in RFC 2080, include support for IPv6 addresses and prefixes, and the use of all-
RIP-routers multicast group address as the destination address for RIP update messages. This
module describes how to configure Routing Information Protocol for IPv6. IPv6 RIP process
maintains a local routing table, referred to as a Routing Information Database (RIB). The IPv6
RIP RIB contains a set of IPv6 RIP routes learnt from all its neighboring networking devices.
Before configuring the router to run IPv6 RIP, the ipv6 unicast-routing must be enabled globally,
and IPv6 must be enabled on any interface in which IPv6 RIP is to be processed.
The list of CLI commands for the configuration of RIP6 are as follows:
ipv6 router rip
ipv6 split-horizon
ipv6 rip enable
ipv6 poison reverse
ipv6 rip default-information originate
ipv6 rip metric-offset
redistribute
distribute prefix
debug ipv6 rip
show ipv6 rip database
show ipv6 rip stats
show ipv6 rip filter
To Next Page
Loading...
