Supermicro SSE-G48-TG4 - Spanning-Tree Transmit Hold-Count

Release : 1.1f 201 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
9.5 spanning-tree transmit hold-count
This command sets the transmit hold-count value and the no form of the command sets the
transmit holdcount to default value. Transmit hold count value is a counter used to limit the
maximum transmission rate of the switch.
spanning-tree transmit hold-count <value (1-10)>
no spanning-tree transmit hold-count
Mode
Global Configuration Mode
Defaults
3
Example
SMIS(config)#spanning-tree transmit hold-count 5
Related Commands
show spanning-tree - Detail - Displays detailed spanning tree information
show spanning-tree - Active - Displays spanning tree information of active ports