Release : 1.1f 594 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
23.22 debug ipv6 pim
This command enables PIMv6 trace and the no form of the command disables PIMv6 trace.
debug ipv6 pim {[nbr][grp][jp][ast][bsr][io][pmbr][mrt][mdh][mgmt] |
[all]}
no debug ipv6 pim {[nbr][grp][jp][ast][bsr][io][pmbr][mrt][mdh][mgmt] |
[all]}
Syntax Description
nbr - Neighbor Discovery traces
grp - Group Membership traces
jp - Join or Prune traces
ast - Assert state traces
bsr - Bootstrap/RP traces
io - Input Output traces
pmbr - Interoperability traces
mrt - Multicast Route Table Update traces
mdh - Multicast Data Handling traces
mgmt - Configuration traces
all - All traces
Mode
Privileged EXEC Mode
Example
SMIS# debug ipv6 pim all
A Four byte integer value is specified for enabling the level of debugging. Each bit in the four byte
integer variable represents a level of debugging. Combinations of levels are also allowed. The
user has to enter the corresponding integer value for the bit set.
Related Command
show ipv6 pim interface– Displays the PIMv6 interfaces of the router
To Next Page
Loading...
