Supermicro SSE-G48-TG4 - Set Ip Pim Static-Rp

Release : 1.1f 580 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
23.8 set ip pim static-rp
This command enables or disables the Static RP configuration Status. This command specifies
whether to use the configured static- RP.
set ip pim static-rp { enable | disable }
Syntax Description
enable - Enables the Static RP configuration Status
disable - Disables the Static RP configuration Status
Mode
Global Configuration Mode
Defaults
disable
Example
iss (config)# set ip pim static-rp enable
Related Commands
show ipv6 pim rp-set – Displays the RP-set information
show ipv6 pim rp-static – Displays the RP-static information