Release : 1.1f 775 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
28.1 ipv6 enable
This command enables IPv6 processing on an interface that has not been configured with an
explicit IPv6 address. The no form of the command disables IPv6 processing on the interface that
has not been configured with an explicit IPv6 address.
ipv6 enable
no ipv6 enable
Mode
Interface Configuration Mode
Defaults
Disabled
Example
SMIS(config-if)# ipv6 enable
IPv6 is enabled on the default VLAN interface.
Related Commands
ipv6 - address – Configures IPv6 address on the interface
show ipv6 interface – Displays the IPv6 interfaces
To Next Page
Loading...
