Release : 1.1f 948 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
34.1 loop-protect
This command enables or disables the loop protection feature globally on the switch. To enable
loop protection on ports, loop protect command need to be configured on the corresponding port
interfaces also. To enable loop protection on ports, refer the section loop protect – interface.
Loop protection feature is disabled by default.
loop-protect {enable | disable}
Syntax Description
enable – Enables the loop protection feature
disable – Disables the loop protection feature
Mode
Global Configuration Mode
Defaults
disable
Example
SMIS(config)# loop-protect enable
Related Commands
show loop-protect – Displays the loop protection feature status.
To Next Page
Loading...
