Release : 1.1f 558 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
22.24 debug ip pim
This command enables PIM trace and the no form of the command disables PIM trace.
debug ip pim {[nbr][grp][jp][ast][bsr][io][pmbr][mrt][mdh][mgmt] |
[all]}
no debug ip pim {[nbr][grp][jp][ast][bsr][io][pmbr][mrt][mdh][mgmt] |
[all]}
Syntax Description
nbr - Neighbor Discovery traces
grp - Group Membership traces
jp - Join or Prune traces
ast - Assert state traces
bsr - Bootstrap/RP traces
io - Input Output traces
pmbr - Interoperability traces
mrt - Multicast Route Table Update traces
mdh - Multicast Data Handling traces
mgmt - Configuration traces
all - All traces
Mode
Privileged EXEC Mode
Example
SMIS# debug ip pim all
A Four byte integer value is specified for enabling the level of debugging. Each bit in the four byte
integer variable represents a level of debugging. The combinations of levels are also allowed.
The user has to enter the corresponding integer value for the bit set.
Related Command
show ip pim interface– Displays the routers PIM interfaces
To Next Page
Loading...
