Release : 1.1f 544 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
22.10 set mode
This command sets the component mode to sparse or dense.
set mode {sparse | dense}
Syntax Description
sparse - Sparse mode
dense - Dense mode
Mode
PIM Component Mode
Defaults
sparse
Example
SMIS(pim-comp)# set mode dense
Sparse-mode routing protocols use shared trees. In a shared tree, sources forward
multicast datagrams to a directly connected router, the designated router. The designated
router encapsulates the datagram and unicasts it to an assigned RP router, which then
forwards the datagram to members of multicast groups.
Dense mode protocols are data driven, where multicast sources starts sending multicast
data packets and receivers join if they want data packets or prune themselves
Related Command
show ip pim component – Displays the component information
To Next Page
Loading...
