Release : 1.1f 545 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
22.11 rp-candidate rp-address
This command sets the address of the interface, which will be advertised as a Candidate-RP and
the no form of the command disables the address of the interface, which will be advertised as a
Candidate-RP.
rp-candidate rp-address <Group Address> <Group Mask> <IP address>
no rp-candidate rp-address <Group Address> <Group Mask> <RP address>
Syntax Description
Group Address - The IP multicast group address for which this entry contains multicast routing
information
Group Mask - The IP multicast group address mask that, gives the group prefix for which this
entry contains information about the RP
IP address - IP address
Mode
PIM Component Mode
Example
SMIS(pim-comp)# rp-candidate rp-address 224.1.0.0 255.255.0.0
20.0.0.2
A Candidate-RP is a router configured to send periodic Candidate-RP-Advertisement
messages to the BSR, and processes Join/Prune or Register messages for the
advertised group prefix, when it is elected as a RP.
Related Commands
show ip pim rp-set – Displays the RP-set information
show ip pim rp-candidate – Displays the RP-candidate information
To Next Page
Loading...
