Release : 1.1f 685 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
26.34 show ip ospf interface
This command displays OSPF interface information.
show ip ospf interface [ { vlan <integer(1-4069)> | <iftype> <ifnum> }]
Syntax Description
vlan - LSA retransmissions for adjacencies belonging to the VLAN interface
iftype - Interface type, can either be a gi, ex or qx ethernet interfaces
ifnum - Physical interface ID including slot and port number
Mode
Privileged EXEC Mode
Example
SMIS# show ip ospf interface
vlan10 is up, line protocol is up
Internet Address 10.0.0.1, Mask 255.0.0.0, Area 33.0.0.12
AS 1, Router ID 10.0.0.1, Network Type BROADCAST, Cost 1
Transmit Delay is 1 sec, State 4, Priority 1
Designated RouterId 10.0.0.1, Interface address 10.0.0.1
No backup designated router on this network
Timer intervals configured, Hello 10, Dead 40, Wait 40,
Retransmit 5
Hello due in 4 sec
Neighbor Count is 0, Adjacent neighbor count is 0
vlan1 is up, line protocol is up
Internet Address 40.0.0.1, Mask 255.0.0.0, Area 33.0.0.12
AS 1, Router ID 10.0.0.1, Network Type BROADCAST, Cost 1
Transmit Delay is 1 sec, State 5, Priority 1
Designated RouterId 20.0.0.2, Interface address 40.0.0.2
Backup Designated RouterId 10.0.0.1, Interface address
40.0.0.1
Timer intervals configured, Hello 10, Dead 40, Wait 40,
Retransmit 5
Hello due in 4 sec
Neighbor Count is 1, Adjacent neighbor count is 1
Adjacent with the neighbor 20.0.0.2
To Next Page
Loading...
