Release : 1.1f 953 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
34.6 show loop-protect
This command displays the loop protection configuration information.
show loop-protect
Mode
Privileged/User EXEC Mode
Example
SMIS# show loop-protect
Loop Protection : Enabled
Transmit Interval : 5 seconds
Receive action : send-disable
Disable Period : 0 (Keep Disabled)
Loop Protection Configured Interfaces
Interface Status Loop-Detected
--------- ------ --------------
Gi0/1 Down No
Gi0/2 Down No
Related Commands
loop-protect – Enable or disable the loop protection feature
loop-protect - interface – Enable or disable the loop protection feature on port interfaces
loop-protect disable-period – Configures the time for which the loop detected ports are kept down
loop-protect receive-action – Configures the action to be taken when loop a loop is detected
loop-protect transmit-interval – Configures the interval on which loop detection packets are sent
To Next Page
Loading...
