Supermicro SSE-G48-TG4 - Show Ipv6 Pim Mroute

Release : 1.1f 605 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
23.31 show ipv6 pim mroute
This command displays the IPv6 PIM mroute information.
show ipv6 pim mroute [ {compid(1-255) | group <group-address> | source
<source-address> } summary ]
Syntax Description
compid - Component ID
group-address - Indicates the PIMv6 multicast group address using the listed RP
source-address - The network address which identifies the sources for which this entry
contains multicast routing information
summary - Summary of PIMv6 mroute information
Mode
Privileged EXEC Mode
Example
SMIS# show ipv6 pim mroute
IP Multicast Routing Table
--------------------------
Route Flags S: SPT Bit W: Wild Card Bit R: RPT Bit
Timers: Uptime/Expires
Interface State: Interface, State/Mode
PIM Multicast Routing Table For Component 1
(*, ff02::e001:0) ,00:03:54/---3401:510a::3401:51a) Incoming
Interface : vlan1
,RPF nbr : fe80::2:a00:a ,Route Flags : WR
Outgoing InterfaceList :
vlan2, Forwarding/Sparse ,00:03:54/---
SMIS# show ipv6 pim mroute group ff02::e001:0 summary
IP Multicast Routing Table
--------------------------
Route Flags S: SPT Bit W: Wild Card Bit R: RPT Bit
Timers: Uptime/Expires