Release : 1.1f 610 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
24.3 vrrp - ip address
This command sets the Associated IP addresses for the virtual router. The no form of the
command deletes the Associated IP addresses for the virtual router.
vrrp <vrid(1-255)> ipv4 <ucast_addr > [secondary]
no vrrp <vrid(1-255)> ipv4[<ucast_addr>[secondary]]
Syntax Description
vrid - Virtual Router ID
ipv4 - IP address
secondary - Associated IP addresses
Mode
VRRP Interface Configuration Mode
Example
SMIS(config-vrrp-if)# vrrp 3 ipv4 10.0.0.1
VRID is a number which along with an interface index uniquely identifies a virtual router on a
given VRRP router.
Once this command is executed, the VRRP Module starts the transition from "Initial" state to
either "Backup" state or "Master" state as per the election process on the specific interface
This command should precede any other interface command for this vrid.
Related Commands
router vrrp – Enables VRRP in the router
show vrrp – Displays the VRRP status information
To Next Page
Loading...
