Release : 1.1f 441 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
16.3.20 show ip dhcp server pools
This command displays the DHCP server pools.
show ip dhcp server pools
Mode
Privileged EXEC Mode
Example
SMIS# show ip dhcp server pools
Pool Id : 1
-------------------------------------------
Subnet : 12.0.0.0
Subnet Mask : 255.0.0.0
Lease time : 180 secs
Start Ip : 12.0.0.1
End Ip : 12.255.255.255
Exclude Address Start IP : 12.0.0.1
Exclude Address End IP : 12.0.0.10
Pool Id : 2
-------------------------------------------
Subnet : 20.0.0.0
Subnet Mask : 255.0.0.0
Lease time : 7200 secs
Start Ip : 20.0.0.1
End Ip : 20.255.255.255
Related Commands
service dhcp-server - Enables the DHCP server
ip dhcp pool - Creates a DHCP server address pool and places the user in the DHCP pool
configuration mode
lease - Configures the duration of the lease for an IP address that is assigned from ISS
Dynamic Host Configuration Protocol (DHCP) Server to a DHCP client
network - Sets the network IP and mask in DHCP server configuration parameters
To Next Page
Loading...
