Release : 1.1f 678 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
26.27 ip ospf dead-interval
This command sets the interval at which hello packets must not be seen before neighbors declare
the router down and the no form of the command sets default value for the interval at which hello
packets must not be seen before neighbors declare the router down.
ip ospf dead-interval <seconds (0-0x7fffffff)>
no ip ospf dead-interval
Mode
Interface Configuration Mode
Defaults
40
Example
SMIS(config-if)# ip ospf dead-interval 1000
This value must be the same for all routers and access servers on a specific network.
Related Commands
ip ospf retransmit-interval – Specifies the time between link-state advertisement
(LSA) retransmissions for adjacencies belonging to the interface
ip ospf hello-interval – Specifies the interval between hello packets sent on the
interface
ip ospf transmit-delay – Sets the estimated time it takes to transmit a link state update
packet on the interface
show ip ospf interface – Displays OSPF interface information
To Next Page
Loading...
