Release : 1.1f 679 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
26.28 ip ospf cost
This command explicitly specifies the cost of sending a packet on an interface and the no form of
the command resets the path cost to the default value.
ip ospf cost <cost (1-65535)> [tos <tos value (0-30)>]
no ip ospf cost [tos <tos value (0-30)>]
Syntax Description
cost - Type 1 external metrics which is expressed in the same units as OSPF interface cost that
is in terms of the OSPF link state metric
tos - Type of Service of the route being configured
Mode
Interface Configuration Mode
Defaults
0
Example
SMIS(config-if)# ip ospf cost 10
In general, the path cost is calculated using the following formula: 108 / bandwidth
Using this formula, the default path costs are calculated.
Example: 56-kbps serial link-Default cost is 1785
Ethernet-Default cost is 10
tos can be configured only if the code is compiled with TOS Support
Related Commands
area-default cost– Specifies a cost for the default summary route sent into a stub or NSSA
show ip ospf interface – Displays OSPF interface information
To Next Page
Loading...
