Release : 1.1f 862 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
31.31 ipv6 ospf poll-interval
This command configures the larger time interval, in seconds, between the Hello packets sent to
an inactive non-broadcast multi-access neighbor. The no form of the command sets the default
poll interval for an interface.
ipv6 ospf poll-interval <1-65535>
no ipv6 ospf poll-interval
Mode
Interface Configuration Mode
Defaults
interval - 120
Example
SMIS(config-if)# ipv6 ospf poll-interval 30
Related Command
show ipv6 ospf interface – Displays the OSPFv3-related interface information
To Next Page
Loading...
