Release : 1.1f 631 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
25.9 default-metric
This command sets the metric to be used for redistributed routes and the no form of the
command sets the metric used with redistributed routes to its default value.
default-metric <value>
no default-metric
Mode
Router Configuration Mode
Defaults
3
Example
SMIS(config-router)# default-metric 1
The default-metric command is used in conjunction with the redistribute router configuration
command to cause the current routing protocol to use the same metric value for all redistributed
routes.
Related Commands
redistribute – Enables redistribution of corresponding protocol routes into RIP
show ip rip – Displays IP RIP protocol database or statistics
To Next Page
Loading...
