Release : 1.1f 282 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
13.2 lacp system-priority
This command sets the LACP priority for the system and the no form of the command sets the
LACP priority for the system to the default value. System Priority represents a 2-octet value
indicating the priority value associated with the system involved in link aggregation.
lacp system-priority <0-65535>
no lacp system-priority
Mode
Global Configuration Mode
Defaults
0x8000 or 32768
Example
SMIS(config)# lacp system-priority 5
The switch with the lowest system priority value decides the standby and active links
in the aggregation.
Although this is a global configuration command, the priority only takes effect on EtherChannels
that have physical interfaces with LACP enabled.
Related Command
show etherchannel - Displays lacp system-priority value
To Next Page
Loading...
