Release : 1.1f 257 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
10.10 dot1x port-control
This command configures the authenticator port control parameter and the no form of the
command sets the authenticator port control state to force authorized.
dot1x port-control {auto|force-authorized|force-unauthorized}
no dot1x port-control
Syntax Description
force-authorized - All the traffic will be allowed without any restrictions
forceunauthorized - All the traffic over the interface will be blocked
auto - Enables 802.1x authentication on the interface and cause the port to transition to the
authorized or unauthorized state based on the 802.1x authentication exchange between the
server and the client
Mode
Interface Configuration Mode
Defaults
force-authorized
Example
SMIS(config-if)# dot1x port-control auto
The auto keyword can be used only if the port is not configured.
The 802.1x protocol is supported on both Layer 2 static-access ports and Layer 3 routed ports.
Related Commands
dot1x default - Configures dot1x with default values for this port
show dot1x - Displays dot1x information
To Next Page
Loading...
