Release : 1.1f 256 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
start-period - 30 seconds
held-period - 60 seconds
auth-period - 30 seconds
Example
SMIS(config-if)# dot1x timeout quiet-period 30
SMIS(config-if)# dot1x timeout supp-timeout 25
Only one timer can be configured using this command, that is, the user can configure either the
quiet-period or tx-period, but not both.
Related Commands
dot1x default - Configures dot1x with default values for this port
dot1x max-req - Sets the maximum number of EAP retries to the client before restarting
authentication process
dot1x reauthentication - Enables periodic re-authentication of the client
show dot1x - Displays dot1x information
To Next Page
Loading...
