Release : 1.1f 76 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
3.38 ntp server
This command configures the SNTP server information.
The no form of this command removes the given NTP server configuration.
ntp server <ip-address> [key(1-65535)] [interval(6-17)] [prefer]
no ntp server <ip_address>
Syntax Description
ip-address – IP address of NTP sever.
key – key number to add into a trusted key list
interval – exchange message delay for server
prefer – tells which server should have to be more preferable
Mode
Global Configuration Mode
Example
SMIS(config)# ntp server 10.10.1.100 10 prefer
Related Command
ntp broadcast - enables
NTP broadcast with authentication
ntp enable – Enables NTP
To Next Page
Loading...
