Release : 1.1f 74 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
3.36 ntp key
This command is used to add a key to a trusted key list. This command takes key text along with
key identifier.
The no form of this command removes the configured key referred by the given key identifier.
ntp key <key_number (1- 65535)> <key_text>
no ntp key <integer(1-65535)>
Syntax Description
key_number - Any number between 1 to 65535 to identify the key string
key_text – Any string up to 32 characters to be used as key to handshake with NTP servers.
Mode
Global Configuration Mode
Example
SMIS(config)# ntp key 1 abcd
Related Command
ntp broadcast - enables
NTP broadcast with authentication
ntp enable – Enables NTP
To Next Page
Loading...
