Release : 1.1f 537 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
22.3 set ip pim spt-switchperiod
This command specifies the period (in seconds) over which the data rate is to be monitored for
switching to shortest path tree.
set ip pim spt-switchperiod <0-2147483647(in secs)>
Mode
Global Configuration Mode
Defaults
0
Example
iss (config)# set ip pim spt-switchperiod 60
The same period is used for monitoring the data rate for both source and group. To
switch to SPT, this period must be configured.
The SPT (Shortest Path Tree) is used for multicast transmission of packets with the
shortest path from sender to recipients
Related Command
show ip pim thresholds – Displays threshold configured for SPT, RP thresholds, rate limit
values for both SM and DM
To Next Page
Loading...
