Release : 1.1f 582 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
23.10 ipv6 pim rp-candidate rp-address
This command sets the address of the interface, which will be advertised as a Candidate-RP. The
no form of the command disables the address of the interface, which will be advertised as a
Candidate-RP.
ipv6 pim rp-candidate rp-address <Group Address> <Group Mask> <RP-
address>
no ipv6 pim rp-candidate rp-address <Group Address> <Group Mask> <RP
address>
Group Address - IPv6 multicast group address
Group Mask - IPv6 multicast group address mask that gives the group prefix for which the entry
contains information about RP
Syntax Description
RP address - IPv6 address of the Rendezvous Point
Mode
PIM Component Mode
Example
SMIS(pim-comp)# ipv6 pim rp-candidate rp-address ff02::e001:0000
112 3333::1111
A Candidate-RP is a router configured to send periodic Candidate-RP-Advertisement
messages to the BSR, and processes Join/Prune or Register messages for the
advertised group prefix, when it is elected as a RP.
Related Commands
show ipv6 pim rp-set – Displays the PIMv6 RP-set information
show ipv6 pim rp-candidate – Displays the PIMv6 RP-candidate information
To Next Page
Loading...
