Release : 1.1f 965 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
36.4 lldp notification interval
This command configures the time interval on which LLDP traps are sent to SNMP managers
when LLDP information is changed.
The no form of this command resets the notification interval to its default value 5 seconds.
lldp notification-interval <seconds(5-3600)>
no lldp notification-interval
Syntax Description
notification-interval – any number between 5 to 3600
Mode
Global Configuration Mode
Defaults
5 seconds
Example
SMIS(config)# lldp notification-interval 300
Related Commands
show lldp – Displays the LLDP feature information.
To Next Page
Loading...
