Release : 1.1f 845 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
31.15 passive-interface
This command sets the global default passive interface status. All the interfaces created after
executing this command become passive interfaces. The no form of the command resets the
global default passive interface status. All the interfaces created after executing this command
become non-passive interfaces.
passive-interface
no passive-interface
Mode
Router Configuration Mode
Defaults
Disabled
Example
SMIS(config-router)# passive-interface
Related Command
show ipv6 ospf - General Information – Displays general information about the
OSPFv3 routing process
To Next Page
Loading...
