Release : 1.1f 318 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
14.17 shutdown snooping
This command shuts down snooping in the switch and the no form of the command starts and
enables snooping in the switch.
shutdown snooping
no shutdown snooping
Mode
Global Configuration Mode
Defaults
no shutdown snooping
Example
SMIS(config)# shutdown snooping
When shutdown, all resources acquired by the Snooping Module are released to
the system.
For the IGS feature to be functional on the switch, the 'system-control' status must
be set as 'start' and the 'state' must be 'enabled'
Related Command
ip igmp snooping - Enables IGMP snooping in the switch/a specific VLAN
To Next Page
Loading...
