Supermicro SSE-G48-TG4 - Snmp Targetparams

Release : 1.1f 455 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
17.7 snmp targetparams
This command configures the SNMP target parameters. The no form of the command removes
the SNMP target Params
snmp targetparams <ParamName> user <UserName> security-mode {v1 | v2c
| v3 {auth | noauth | priv}} message-processing {v1 | v2c | v3}
[{volatile | nonvolatile}]
no snmp targetparams <ParamName>
Syntax Description
ParamName - SNMP Parameter Name
User - User Name
security-mode - Security Mode
auth - Authentication - Enables Message digest (MD5) or Secure Hash Algorithm (SHA) packet
authentication
noauth - no-authentication
priv - Specifies both authentication and privacy
messageprocessing - Message processing mode
volatile | nonvolatile - Storage type
Mode
Global Configuration Mode
Defaults
ParamName - internet
User/Security Name - None
Security Mode - v2c
Security Level - NoauthNoPriv
Message Processing Mode - v2c
Storage Type - Non-volatile
ParamName - test1
User/Security Name - None
Security Mode - v1
Security Level - NoauthNoPriv
Message Processing Mode - v1