Supermicro SSE-G48-TG4 - Ip Dhcp Relay Circuit-ID

Release : 1.1f 414 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
16.2.4 ip dhcp relay circuit-id
This command configures circuit identifier value to be used by the relay agent on the sub option 1
of the relay information option 82 to DHCP servers. The no form of this command clears the
circuit identifier configuration. This is interface specific configuration.
ip dhcp relay circuit-id <id>
no ip dhcp relay circuit-id
Syntax
<id> - Any number between 1 to 2147483647
Mode
Interface Configuration Mode
Defaults
No circuit id option sent
Example
SMIS(config-if)# ip dhcp relay circuit-id 1000
Related Commands
show ip dhcp relay information - Displays the DHCP relay information
show dhcp server - Displays the DHCP server information