Supermicro SSE-G48-TG4 - Show Ipv6 Ospf Route

Release : 1.1f 884 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
31.48 show ipv6 ospf route
This command displays routes learned by the OSPFv3 process
show ipv6 ospf route
Mode
User/Privileged EXEC Mode
Example
SMIS# show ipv6 ospf route
Dest/ NextHop/ Cost Rt.Type Area
Prefix-Length IfIndex
3ffe::10:0:0:0 fe80::290:69ff: 30 interArea 0.0.0.0
/80 fe90:b4bf /vlan1
3ffe::20:0:0:0 fe80::290:69ff: 20 interArea 0.0.0.0
/80 fe90:b4bf /vlan1
3ffe::30:0:0:0 :: /vlan1 10 intraarea 0.0.0.0
/80
3ffe::40:0:0:0 fe80::211:22ff: 20 intraArea 0.0.0.0
/80 fe33:4423 /vlan1
3ffe::40:0:0:5 fe80::211:22ff: 20 interArea 0.0.0.0
/128 fe33:4426 /vlan2
3ffe::40:0:0:5 fe80::211:22ff: 20 interArea 0.0.0.0
/128 fe33:4423 /vlan1
3ffe::50:0:0:0 :: /vlan2 10 intraArea 0.0.0.0
/80
3ffe::60:0:0:0 fe80::211:22ff: s20 interArea 0.0.0.0
/80 fe33:4426 /vlan2
3ffe::60:0:0:6 fe80::211:22ff: 10 interArea 0.0.0.0
/128 fe33:4426 /vlan2
Related Commands
ipv6 router ospf – Enables the OSPFv3 routing protocol
router-id – Sets a fixed router ID