Release : 1.1f 35 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
speed of the interface to its default value.
duplex This command configures the duplex operation
and the no form of the command configures the
duplex operation to the default value.
monitor session This command enables port-mirroring in the
switch and the no form of the command
disables port mirroring in the switch.
hol blocking prevention This command enables the Head-Of-Line
blocking prevention on the interface and the no
form of the command disables the same.
storm-control This command sets the storm control rate for
broadcast, multicast and DLF packets and the
no form of the command sets storm control rate
for broadcast, multicast and DLF packets to the
default value.
rate-limit This command configures the output rate
limiting for the interfaces.
snmp trap link-status This command enables trap generation on
either the physical interface or the port-channel
interface.
reset interface statistics This command clears interface counters.
reset interface cpu statistics This command clears CPU counters.
show ip interface This command displays the IP interface
configuration.
show interfaces This command displays the interface status
and configuration.
show interfaces - counters This command displays the interface statistics
for each port.
show interfaces cpu counters This command displays the CPU statistics for
each port.
show interface mtu This command shows the Maximum
Transmission Unit (MTU) of ports in the switch.
show conf This command displays the interface specific
running configuration.
show port-monitoring This command displays port-monitoring
To Next Page
Loading...
