Release : 1.1f 34 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
Command Description
interface This command selects an interface to
configure, which can be a physical interface or
a port-channel interface or a VLAN interface or
OOB (Out of Band) interface. The no form of
the command is used to delete a VLAN / port-
channel interface. On execution of this
command, the user enters the interface
configuration mode for that interface.
description This command configures the description string
to the port interfaces.
switchport This command configures the port as switch
port. The no form of the command configures
the port as router port.
ip address This command sets the IP address of an
interface. The no form of the command resets
the IP Address for the given Interface.
ip address dynamic
This command configures the current VLAN
interface to dynamically acquire an IP address
from the RARP/DHCP Server. The no form of
the command resets the IP Address for the
Interface
mtu frame size This command configures the maximum
transmission unit frame size for the interface.
system mtu frame size This command configures the maximum
transmission unit frame size for all the
interfaces on the switch.
flowcontrol This command is used to set the send or
receive flow-control value for an interface.
shutdown - physical/VLAN/port-channel This command disables a physical
interface/VLAN interface/port-channel interface
negotiation This command enables auto-negotiation on the
interface and the no form of the command
disables auto negotiation on the interface.
speed This command sets the speed of the interface
and the no form of the command sets the
To Next Page
Loading...
