Release : 1.1f 663 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
For example, a summary-LSA for the destination 128.185.0.0 with a mask of 0xffff0000 actually is
describing a single route to the collection of destinations 128.185.0.0 - 128.185.255.255
This command is used only with Area Border Routers (ABRs). It is used to consolidate or
summarize routes for an area. The result is that a single summary route is advertised to other
areas by the ABR.
Related Commands
ip ospf authentication – Specifies the authentication type for an interface
area-default cost – Specifies a cost for the default summary route sent into a stub or
NSSA
area- nssa – Configures an area as a NSSA and other parameters related to that area
area-stub– Specifies an area as a stub area and other parameters related to that area
area - virtual-link – Defines an OSPF virtual link and its related parameters
summary-address – Creates aggregate addresses for OSPF
show ip ospf - summary address – Displays OSPF Summary-address redistribution
Information
To Next Page
Loading...
