Release : 1.1f 223 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
Spanning Tree port pathcost method is Long
Spanning tree enabled protocol is MSTP
MST00 Port Roles and States
Port-Index Port-Role Port-State Port-Status
---------- --------- ---------- -----------
7 Designated Forwarding Enabled
8 Root Forwarding Enabled
9 Alternate Discarding Enabled
10 Disabled Discarding Enabled
11 Disabled Discarding Enabled
12 Disabled Discarding Enabled
This command is the same for both RSTP and MSTP.
Related Commands
spanning-tree mode - Sets the spanning tree operating mode
spanning-tree - Enables the spanning tree operation
spanning-tree provider – Enables the spanning tree operation
spanning-tree compatibility - Sets the compatibility version for the spanning tree
protocol
spanning-tree timers - Sets the spanning tree Timers
spanning-tree transmit hold-count - Sets the transmit hold-count value
spanning-tree priority - Sets the Bridge Priority for the spanning tree only in steps of
4096
spanning-tree - Properties of an interface - Sets spanning tree properties of an
interface
spanning-tree mst- Properties of an interface for MSTP - Sets the spanning
tree properties of an interface for MSTP
show spanning-tree bridge - Displays the spanning-tree configuration of the bridge
show spanning-tree interface - Displays Spanning-tree port configuration
spanning-tree pathcost method - Sets the method to calculate the default port path cost
To Next Page
Loading...
