Release : 1.1f 293 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
Number of channel-groups in use: 1
Number of aggregators: 1
Group Port-channel Protocol Ports
----------------------------------------------------------
1 Po1(P) LACP Gi0/1(P),Gi0/2(P)
SMIS# show etherchannel 1 protocol
Channel Group Listing
---------------------
Group : 1
----------
Protocol : LACP
SMIS# show etherchannel load-balance
Channel Group Listing
---------------------
Group : 1
----------
Source IP Address
If the channel group number is not specified details on all channels are displayed.
Related Commands
channel-group - Assigns an Ethernet interface to an EtherChannel group
set port-channel - Enables/disables link aggregation in the switch
lacp system-priority - Sets the LACP priority for the system
port-channel load-balance - Sets the load balancing policy
lacp port-priority - Sets the LACP port priority
lacp wait-time - Sets the LACP wait-time
lacp timeout - Sets the LACP timeout period
show interfaces - Displays interface specific port-channel information
To Next Page
Loading...
