Release : 1.1f 660 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
retransmit-interval - 5
transmit-delay - 1
dead-interval - 40
Example
SMIS(config-router)# area 10.0.0.1 virtual-link 20.0.0.1 authentication
message-digest hello-interval 100 retransmitinterval 100 transmit-delay
50 dead-interval 200 authenticationkey asdf
In OSPF, all areas must be connected to a backbone area. If the connection to the backbone is
lost, it can be repaired by establishing a virtual link hello-interval and dead-interval: The value
must be the same for all routers and access servers on a specific network
Related Commands
area - range – Consolidates and summarizes routes at an area boundary
ip ospf authentication – Specifies the authentication type for an interface
show ip ospf info– Displays general information about OSPF routing process
show ip ospf virtual-links – Displays OSPF Virtual link information
To Next Page
Loading...
