Release : 1.1f 665 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
SMIS(config-router)# summary-address 10.0.0.6 255.0.0.0 10.0.0.0
allowAll Translation enabled
When translation {enabled | disabled} is set to enabled, the NSSA border router's
futOspfAreaNssaTranslatorRole has been set to always. When this object is set to disabled, a
candidate NSSA Border router does not perform translation. Indicates whether Type-5/Type-7 will
be aggregated or not generated for the specified range. allowAll and denyAll are not valid for
areaId other than 0.0.0.0.
Routes learnt from other routing protocols can be summarized. The metric used to advertise the
summary is the smallest metric of all the more specific routes.
This command helps reduce the size of the routing table.
Related Commands
ip ospf authentication-key – Specifies a password to be used by neighboring routers
that are using the OSPF simple password authentication
area - range – Consolidates and summarizes routes at an area boundary
ip ospf message-digest-key – Enables OSPF MD5 authentication
show ip ospf - summary address – Displays OSPF Summary-address redistribution
Information
show ip ospf - database summary – Displays OSPF LSA Database summary
To Next Page
Loading...
