Release : 1.1f 940 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
priority - The priority of the L2 filter is used to decide which filter rule is applicable when the
packet matches with more than one filter rules. Higher value of 'filter priority' implies a higher
priority
Mode
ACL MAC Configuration Mode
Defaults
vlan-id - 0
priority - 1
Example
SMIS(config-ext-macl)# permit host 00:11:22:33:44:55 any
aarp priority 10
MAC access list must have been created.
Related Commands
mac access-list extended - Creates Layer 2 MAC ACLs, and returns the MAC-Access list
configuration mode to the user
mac access-group - Applies a MAC access control list (ACL) to a Layer 2 interface
deny - Specifies the packets to be rejected based on the MAC address and the associated
parameters
redirect - Specifies the packets to be redirected based on the MAC address and the
associated parameters
show access-lists - Displays the access list statistics
To Next Page
Loading...
