Microsemi SmartFusion2 - Design Flow

Inter-Integrated Circuit Peripherals
UG0331 User Guide Revision 15.0 544
15.3 How to Use I
2
C
This section describes how to use I
2
C in an application.
15.3.1 Design Flow
The following steps are used to enable the I
2
C in the application by using Libero SoC.
1. Enable I2C_0 and/or I2C_1 instance by using the MSS configurator in the application, as shown in
the following figure.
Figure 232 • Enable I
2
C