Microsemi SmartFusion2 - Configuring FIC_2 (Peripheral Initialization) Using Libero Soc; Figure 358 Configure FIC_2 in MSS Configurator

APB Configuration Interface
UG0331 User Guide Revision 15.0 787
25.2 How to Use
This section describes how to use the FIC_2 (Peripheral Initialization) subsystem in the design.
25.2.1 Configuring FIC_2 (Peripheral Initialization) Using Libero SoC
This section describes the FIC_2 (Peripheral Initialization) configuration in Libero SoC and shows
options available for configuring FIC_2. The FIC_2 is not configured by default in the MSS configurator
when the Libero SoC project is created. The following steps are required.
25.2.1.1 Step 1
Instantiate the SmartFusion2 MSS component into the Libero project and configure (enable/disable) the
peripherals using MSS configurator, as required.
25.2.1.2 Step 2
Double-click FIC_2 (Peripheral Initialization) or right-click FIC_2 and select Configure, as shown in the
following figure.
Figure 358 • Configure FIC_2 in MSS Configurator
The following options are available in the APB configuration interfaces of SERDES and DDR
subsystems.
• Initialize peripherals using Cortex-M3 processor
• MSS DDR
• Fabric DDR and/or SERDES Blocks